DI-1M Impact & Continuous Drive Digital Torque Tester
Verify Settings on Pneumatic, Electric, Pulse and Continuous Drive Torque Wrenches and Drivers
Standard Features
- Ergonomic light weight, torque tester with heavy duty metal construction
- Easy to read LED panel displays reference torque value in lbf-ft, kgf-m and N-m (selectable) and number of blows for selected period (0.1 – 9.9 sec)
- Peak, Real Time and Peak Down measuring modes (selectable)
- Accuracy: ±0.5% F.S. ±1 LSD ( 32° to 100°F)
- Both clockwise and counterclockwise operation
- USB Virtual COM port (peak data only)
- Runs on internal NiMH batteries (8 hour use)
- AC charger included
The DI-1M Digital Torque Tester is perfectly suited for on-the-spot calibration of impact drivers and air tools. Calibrate your own air tools and impact wrenches and save down time. These fast response units give a digital readout of peak value in either clockwise or counterclockwise direction and also indicate the number of blows for a selected time period from 0.1 to 9.9 seconds. These instruments have an accuracy of ±0.5%, ±1 LSD and lbf-in/lbf-ft, kgf-cm/kgf-m, or N-cm/N-m units are selectable. Virtual RS-232 serial output, auto zero reset, auto shutoff and low battery indicator complete the set of features. It is powered by an internal NiMH battery or the included AC adapter.
Operation Modes
Peak, Real Time and Peak Down modes are selectable. Peak mode captures the peak torque achieved during a test. PEAK reading will not change until a higher value is measured. Real Time mode displays the real time transient torque value. Peak down captures the critical first peak value and will not change even if a higher value is subsequently measured.
The DI-1M also provides peak data for SPC (statistical process control) via the USB Virtual COM port. Click on the link here for torque tester data acquisition software.
What’s Included
Choose from four different remote sensors for the DI-1M, available in ranges up to 362 lbf-ft with 3/8″, 1/2″ or 3/4″ drives. All testers include a 3 Point Certificate traceable to NIST, ISO-17025 Certificates are available at an extra charge. The kit includes the remote sensor, display unit, cable and AC adapter/charger.
The blow counter displays number of blows and value of torque, and LED display which is brighter and easier to read.
Besides, it can be used for the management of the torque wrench · nut runner.
- Blow counter shows number of blows and value of torque
- Enable to inspect operating torque of manual preset type torque wrench etc. in peak down mode
- Auto power-off function · Autoclear function are installed
- Data acquisition software can be downloaded for free
- The lineup of the DI-1M-IP series is DI-1M-IP50, DI-1M-IP200
